BOSS 302 Exchange

BOSS 351 Forums => BOSS 351 Cars/Parts Wanted => Topic started by: kitdoctor on July 19, 2018, 04:15:37 pm

Title: WTB Genuine Carb Stud
Post by: kitdoctor on July 19, 2018, 04:15:37 pm
Chasing correct carb stud for Autolite 4300-D B1 carb. No repros thanks.
Title: Re: WTB Genuine Carb Stud
Post by: 9464larry on July 21, 2018, 01:39:26 pm
might have some nos,do you have a pic or  measurements of a original
Title: Re: WTB Genuine Carb Stud
Post by: Danny_boyzz on January 09, 2019, 06:07:59 am
Hi
Also want to buy.
Carb stud for the Boss 351 Autolite 4300-D carb.
Overall length 4 3/8 inches, long end is 2 ½ inches, ¼-20 thread on both ends, diameter is 1/4 inch on both ends, short end has nylon insert in the threads, 3/8 inch hex.
The nylon button is .125 diameter and is .200 in from the short end. And to a depth of what ever is required. On the short length side the hex edges are radius to about .062, and no radius on the long length side. The finish is a black oxide.
Thank you
Dan
danielphemi71@cs.com

(https://i.imgur.com/YeZJKRs.jpg)
Title: Re: WTB Genuine Carb Stud
Post by: kitdoctor on September 02, 2019, 01:09:44 am
 Hi Larry sorry I did not respond. Not long after I started a house renovation (away from where I actually lived) and was consumed...
Noel