Author Topic: WTB Genuine Carb Stud  (Read 951 times)

0 Members and 1 Guest are viewing this topic.

Offline kitdoctor

  • Cool Newbie
  • **
  • Posts: 92
WTB Genuine Carb Stud
« on: July 19, 2018, 04:15:37 pm »
Chasing correct carb stud for Autolite 4300-D B1 carb. No repros thanks.
71 Boss 351 - Grabber Yellow 1F02R143xxx

Offline 9464larry

  • Senior Member
  • ****
  • Posts: 214
Re: WTB Genuine Carb Stud
« Reply #1 on: July 21, 2018, 01:39:26 pm »
might have some nos,do you have a pic or  measurements of a original

Offline Danny_boyzz

  • Cool Newbie
  • **
  • Posts: 29
Re: WTB Genuine Carb Stud
« Reply #2 on: January 09, 2019, 06:07:59 am »
Hi
Also want to buy.
Carb stud for the Boss 351 Autolite 4300-D carb.
Overall length 4 3/8 inches, long end is 2 ½ inches, ¼-20 thread on both ends, diameter is 1/4 inch on both ends, short end has nylon insert in the threads, 3/8 inch hex.
The nylon button is .125 diameter and is .200 in from the short end. And to a depth of what ever is required. On the short length side the hex edges are radius to about .062, and no radius on the long length side. The finish is a black oxide.
Thank you
Dan
danielphemi71@cs.com


« Last Edit: October 04, 2019, 06:38:36 am by Danny_boyzz »

Offline kitdoctor

  • Cool Newbie
  • **
  • Posts: 92
Re: WTB Genuine Carb Stud
« Reply #3 on: September 02, 2019, 01:09:44 am »
 Hi Larry sorry I did not respond. Not long after I started a house renovation (away from where I actually lived) and was consumed...
Noel
71 Boss 351 - Grabber Yellow 1F02R143xxx