Author Topic: Boss 302 Windage tray bolts...  (Read 153 times)

0 Members and 1 Guest are viewing this topic.

Offline mercerjeff

  • Cool Newbie
  • **
  • Posts: 20
  • 0F02G118472
Boss 302 Windage tray bolts...
« on: February 10, 2019, 09:25:02 am »
Hi Guys,

    Looking for a set of windage tray main cap bolts, need all 4....

Thanks, Jeff

Offline CaBossFan

  • Needs A Job
  • ******
  • Posts: 4,339

Offline mercerjeff

  • Cool Newbie
  • **
  • Posts: 20
  • 0F02G118472
Re: Boss 302 Windage tray bolts...
« Reply #2 on: February 11, 2019, 04:58:16 pm »
Bolts found...

Thanks, guys...

Offline pbf777

  • Cool Newbie
  • **
  • Posts: 93
Re: Boss 302 Windage tray bolts...
« Reply #3 on: February 12, 2019, 08:19:57 am »
     I would recommend the use of the latter, 'taller' head vs. the earlier 'shorter' head (perhaps "correct") bolt configuration, as it has been witnessed that the original shorter head when counter drilled & tapped in it's manufacture to receive the tray retaining bolt, resulted in an insufficient area of material remaining at the juncture of the bolts' head and shank, leading to a not so uncommon separation of the fastener's hex head in service.............oops!    :o

     Scott.