Author Topic: WTB decklid springs for a rear spoiler car  (Read 330 times)

0 Members and 1 Guest are viewing this topic.

Offline Joe69

  • Cool Newbie
  • **
  • Posts: 87
WTB decklid springs for a rear spoiler car
« on: February 24, 2019, 06:32:28 am »
Like the title says, I'm looking for the heavier spring required for a decklid on a factory rear spoiler car.
Please contact me if you have one.

Thanks,
Joe


67 Fastback
'69 Mach 1
'71 Boss 351

Offline B1n71

  • Cool Newbie
  • **
  • Posts: 64
Re: WTB decklid springs for a rear spoiler car
« Reply #1 on: February 24, 2019, 07:07:17 pm »
Good luck! I have been looking for a year with no success.

Offline Danny_boyzz

  • Cool Newbie
  • **
  • Posts: 29
Re: WTB decklid springs for a rear spoiler car
« Reply #2 on: March 21, 2019, 05:44:47 am »
Torsion bar springs for spoiler decklid are .230 inch in diameter. Non-spoiler are .200 inch in diameter.
Looking to.
Danny

Offline B1n71

  • Cool Newbie
  • **
  • Posts: 64
Re: WTB decklid springs for a rear spoiler car
« Reply #3 on: March 21, 2019, 11:24:52 am »
Can’t tell by looking and there is no part number on them!

Here are the part numbers:

Trunk torsion rods for spoiler D1ZZ-66344890-B and D1ZZ-6344891-B

The for use with a spoiler are (D1ZZ-66344890-B and D1ZZ-6344891-B)

Offline BossRaver

  • Senior Member
  • ****
  • Posts: 243
Re: WTB decklid springs for a rear spoiler car
« Reply #4 on: March 21, 2019, 01:53:13 pm »
I have two torsion rods from a 1971 Mach-1 that I parted out due to rust issues but they measure .280". Thicker than the .230 mentioned. What do these fit?    Ed Raver